Printers

How do I setup the Zebra Label Printer?

Procedure

  1. Go to https://www.zebra.com/us/en/support-downloads/printers/desktop/gc420t.html#downloadlistitem_9aa
  2. Download and install “Zebra Setup Utilities for Windows”
  3. Connect Zebra printer to computer
  4. Go to Control Panel -> Devices and Printers
  5. Look for device that starts with "F" under Unspecified.  Right click and select Properties
  6. Change the Port to COM4 and add driver for Zebra ZDesigner GC420t
  7. Click OK 

Zebra Printer Properties.png

How do I add a new printer?

Procedure

  1. Go to Control Panel
  2. In the top right, if Control Panel is set to View By Category change Category to Small Icons

    image.png

  3. Click Devices and Printers
  4. Click Add Printer
  5. Click The printer I want to add isn’t listed
  6. Click Add printer by TCP/IP
  7. Enter the printer's IP address and click Next.  

After a few seconds the printer should be detected and the printer make and model will be set as the printer name.  During the process of adding the printer you may receive a prompt asking if you want to share the printer. If so select “Do not share this printer”. 

Follow the rest of the prompts until the Finish button appears.

How do I setup the CHT HP Printer?

Printer Information

Office Jet Pro 8030 series
IP address: 10.211.24.230
Host Name: HP74DEB8

Procedure

  1. Download and install software from:  https://ftp.hp.com/pub/softlib/software13/COL107186/mp-275092-2/HPEasyStart_13_2_5.exe
  2. Follow prompts to add printer via IP address: 10.211.24.230
  3. After printer software is installed go to Control Panel -> Devices and Printers
  4. Right Click HP OfficeJet Pro 8030 and click Printer Properties
  5. Click the Ports tab
  6. Click Add Port…
  7. Click Standard TCP/IP Port and click New Port…
  8. Click Next
  9. In the Printer Name or IP Address field type 10.211.24.230
  10. Click Next
  11. Click Finish

How do I set my printers IP?

Here’s how to reset the port setting and resume printing on the DaVinci printer:

Procedure

  1. Go to Control Panel
  2. If Control Panel is set to View By Category change Category to Small Icons

    image.png

  3.  

    Click Devices and Printers
  4. Right click DaVinci – HP LaserJet 600 and click Printer properties
  5. Click the Ports tab
  6. Click Add Port…
  7. Click Standard TCP/IP Port and click New Port…
  8. Click Next
  9. In the Printer Name or IP Address field type 169.237.157.172
  10. Click Next
  11. Click Finish

These steps apply to any printer on the EPM network. Check the IP Address spreadsheet for IP Addresses of other printers.